Don't fret! We have A sharp project for you to jam out.
CUT
Import the included files and cut all the pieces from their respective materials. This file contains vector cuts and vector markings.
Assemble
First you will want to paint, stain, and mark all the pieces of your guitar individually. Remember you can always use your laser and vector markings to make stencils and designs over your cuts.
Once all your pieces are how you want them you can glue the neck of the guitar to the body.
After the neck is in place you can glue the pickgaurd down to the body.
Then you can glue the pickups into the holes of the pickgaurd. These are double layered,stacked, and glued to give more dimension to the project.
There are several other double layered componants that will need to be stacked, glued, and set in place. With an exception of the knobs, all of these are very straight forward due to the vector markings of the project.
Moving onto the strings, first start by wraping the wire around the bottom tuning peg. Once wraped you will want to feed the wire though the closest hole from the back. Then you will want to run the wire down the front of the guitar stringing it through the corresponding hole. Finally bringing the wire up the back of the guitar and wrapping aroung the next tuning peg restarting the whole process. *NOTE* We used a single piece of wire that measured 24 ft.
If you pulled your strings too tight when stringing your guitar the neck will pull forward. To eliminate this you can use the shape below to bring the strings together and pull the neck back into place. This piece does not have to be glued in place and can actually be slid up and down to change the tension of the strings.
You can now slide in the top nut, this will keep your strings in place.
After the guitar is finished we can move onto the strap. Take the large secton of the strap and slide it into thepiece shown below.
Now you can glue the smaller section to the larger section and slide the additional piece over the glued area.
Finally insert the bottom strap peg into the larger section of the strap. Do this again for the top strap peg/top of the strap.
Well Done!